PGRT - IP SLA Jitter - Cisco 2911 IOS15.2
I have read some of the other questions but still not found an answer, I am looking to capture Jitter on my PRTG and I have setup the router as required but I am unable to get PRTG to capture the...
View Articlehow to create SLA sensor?
Hi everyone! Help me please! How to create SLA sensor including: ping, latency, packet loss
View ArticleIP SLA sensor down
Setup IP SLA on Cisco and PRTG. PRTG sensorshowing IP SLA is not in service. Code:PE109Cisco CLI is showing IP SLA reports and wireshark is showing SNMP get-respond with vlauesPlease adviseThank you
View ArticleIP SLA - path-jitter
Morning Support Team,We have recently added some new IP SLA path-jitter sensors to our network to help monitor packet delivery for COS. Unfortunately when I added them to PRTG I get the following...
View ArticlePRTG does not work with path-jitter
We are faced with the fact that our PRTG(14.3.11.2750) does not work with cisco ip sla path-jitter. Ip sla was configured as follows: ip sla 1 path-jitter x.x.x.x targetOnly vrf xxxx ip sla schedule 1...
View ArticleDisable "Down" status
Is there a way to disable the "Down" status for sensors (or at least NOT monitor the down status)? I understand that the "Auto-Acknowledge" state works for sensors that are down for extended periods of...
View ArticleWrong max-latency value retrieved using Cisco IP-SLA udp-jitter sensor
I have a Cisco IP SLA up-jitter sensor retrieving statistics from a Cisco Switch and I have noticed that one of the values (Max Latency Source-to-Destination) is not retrieved correctly, showing values...
View ArticlePing to different host from Fortigate 80E
Hello all,I need to verify connectivity from my fortigate 80E (Core switch in a branch office), to different hosts (being exchange servers, Internet gateway etc). I'm using a tunnel across internet to...
View ArticleHow are IP SLA sensors read in detail?
We have tested some IP SLA Sensors. But given following scenario:We setup a sensor that sends a UDP echo 10x/second to a destination. PRTG gets his values after 10sec (earliest you can configure PRTG...
View ArticleCisco IP SLA sensor with only AVG RTT channel
Hi, I've tried several different IP SLA probles on Cisco switch (icmp-echo, icmp-jitter, tcp-connect), however every time I add this IP SLA as a sensor to PRTG I only see AVG RTT channel and no other....
View Article
